HDRI Community
http://www.hdrlabs.com/cgi-bin/forum/YaBB.pl
Open Camera Controller >> OCC Developer Zone >> Compilation Errors with dSerial
http://www.hdrlabs.com/cgi-bin/forum/YaBB.pl?num=1291168942

Message started by jpopadic on 12/01/10 at 02:02:22

Title: Compilation Errors with dSerial
Post by jpopadic on 12/01/10 at 02:02:22
I've got the OCCBracket close to building per the instructions on the site.

CARD_CR1 and CARD_EEPDATA don't appear to be defined.  Has anyone else had this issue?

J

Title: Re: Compilation Errors with dSerial
Post by Steve Chapman on 12/02/10 at 21:04:54
I need elaboration...what is your dev environment, 2008 or 2010.net?. I haven't been able to recreate this issue, could you check the contents of dserial.c and card_spi.c to see if any inadvertant changes have taken place?

Title: Re: Compilation Errors with dSerial
Post by Steve Chapman on 12/03/10 at 16:30:07
I also should add, you could excise references to dserial in main.c if you are not planning on using a motor mount.

HDRI Community » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2018. All Rights Reserved.