HDRI Community
http://www.hdrlabs.com/cgi-bin/forum/YaBB.pl
Open Camera Controller >> OCC Developer Zone >> Clock based intervalometer 1.1
http://www.hdrlabs.com/cgi-bin/forum/YaBB.pl?num=1237765114

Message started by spdorsey on 03/23/09 at 00:38:32

Title: Clock based intervalometer 1.1
Post by spdorsey on 03/23/09 at 00:38:32
I was playing around with this. Thanks for the ability to shoot in intervals less than 1 minute!   :)

 I set the camera to shoot every 5 seconds. Works fine. But when I closed the lid, it went a little bit crazy.

 I'm guessing that the start and new numbers on screen represent the DS time, in a format I do not recognize. The Wait time is clear, but when I close the lid of the DS, the camera stops shooting, and the wait time goes negative. When I open the DS back up, the camera "tries to catch up" and shoots erratically. After a while, it finds balance again and shoots normally.

 Works great if I don;t close the lid.

Thanks

------------S

Title: Re: Clock based intervalometer 1.1
Post by steve on 03/23/09 at 00:43:20
Only version 1.2 of the bracketer supports lid-closure at this point. I'll have to re-compile the older programs to support this feature.

HDRI Community » Powered by YaBB 2.5.2!
YaBB Forum Software © 2000-2018. All Rights Reserved.